Eight Accessorial Charge Mistakes That Inflate Freight Bills, and the Contract Fixes
You negotiated the linehaul rate, but the carrier's tariff still sets the price of detention, liftgate, re-delivery and fuel. Here are seven leaks on freight bills, and the contract clause, TMS rule or audit check that closes each one.
Leaving accessorials on the carrier's default rules tariff
Most freight negotiations end once the linehaul rate is agreed. The contract then says the carrier's rules tariff applies "as amended from time to time," and that one phrase lets the carrier reprice every freight accessorial charge during the term without asking you. Say a distributor spends $4 million a year on truckload and LTL and wins a 5% linehaul cut. If accessorials run around 10% of spend and nobody controls them, a single tariff update can hand back much of that saving. (This is a hypothetical, but the mechanism is real.)
The same thing happens outside North America under other names. Forwarders in Europe often work under standard trading conditions such as BIFA terms in the UK or ADSp in Germany. Ocean carriers bill terminal and local charges from published tariffs. Road carriers in India and the Gulf usually attach their own rate cards.
What to do instead: attach a named accessorial schedule as an exhibit. Add a precedence clause stating that the exhibit overrides any tariff, bill of lading or general conditions. Freeze the prices for the contract term, and make any charge code missing from the exhibit unpayable unless you approved it in writing and gave it a reference number.
| Charge | Common regional names | Typical billing basis (indicative 2026 USD ranges) |
|---|---|---|
| Truck detention | Detention (North America), waiting time or standstill (UK/EU), halting charges (India), waiting charges (Gulf) | Roughly $40–$100 per hour after 1–2 free hours, or about $150–$450 per day |
| Ocean demurrage and detention | D&D; the equipment-side charge is often called per diem in North America | Roughly $50–$300 per container per day, rising in tiers |
| Liftgate | Tail lift (UK/EU, Australia) | Roughly $50–$150 per shipment |
| Residential / limited access | Residential surcharge, remote area or delivery area surcharge | A few dollars per parcel; roughly $75–$175 per LTL shipment |
| Re-delivery | Failed delivery or reattempt fee | Roughly $75–$250 per attempt, or the full minimum charge |
| Truck ordered not used | TONU, dry run, dead freight | Roughly $150–$450 per event |
These are typical 2026 market ranges. They vary by contract, lane and country, so confirm them with your carriers.
Agreeing to detention without a start time or a proof standard
Truck detention disputes nearly always come back to one question: when did the clock start? If the contract only says "two hours free," the carrier will count from the moment the truck arrived, even when it showed up three hours early with no appointment.
What to do instead: write the trigger rules into your carrier contract terms:
- Free time starts at the scheduled appointment or at check-in, whichever is later. Early arrivals earn nothing until the appointment time.
- The carrier must notify you in writing (a portal message or email to a named address) before free time runs out. Without that notice, the charge can't be billed.
- Every claim needs timestamped evidence: ELD or telematics data, gate logs, or signed in-and-out times on the delivery note.
- Charges are capped per stop, for example at eight hours, with a layover rate beyond the cap.
- Detention billed more than 30 days after delivery is waived.
For multi-stop and drop-trailer moves, define free time per stop and per trailer. In the EU, driver-hours rules can turn a long wait into a mandatory rest period, so agree standstill day rates in advance rather than leaving them to an hourly meter.
Treating detention and demurrage charges as an unavoidable port cost
On ocean freight, detention and demurrage charges run on two separate clocks. Demurrage covers the container sitting at the terminal. Detention covers the carrier's equipment once it leaves the terminal. Shippers who negotiate neither end up on tariff free time, which is often only a few days at the port of discharge. After that, daily rates climb in tiers.
What to do instead: put free time into the service contract or the forwarder agreement. Ask for a combined D&D allowance, such as 14 days merged, so time saved on one clock can cover delays on the other. Then add a carve-out: days lost to terminal congestion, customs system outages, carrier-caused delays, or an empty-return depot that refuses the box don't count toward free time.
Billing rules differ by country. In the United States, the Federal Maritime Commission has rules on what a D&D invoice must contain and how long parties have to dispute it. In many other markets, your protection is only what the contract says. Assume the second case wherever you ship, and require itemized invoices showing container number, gate-out and gate-in times, and the free time applied.
Letting bad location data trigger liftgate and residential fees
Most liftgate, residential and limited-access charges come from your own master data. A ship-to record with no dock flag, or a business address that the carrier's database classifies as residential, triggers the fee on every shipment to that location. Parcel carriers including UPS, FedEx and DHL classify addresses automatically. Remote-area surcharges are common across Southeast Asia, the Middle East, Africa and rural Latin America.
What to do instead: make this a TMS rule rather than an audit finding.
- Store dock availability, a residential or limited-access flag, and delivery-hour restrictions on every ship-to record. Require those fields before a new customer location can be activated.
- Rate the accessorial at quote time, so the shipment is booked with a tail lift or residential service when needed. Accessorials booked up front are usually cheaper than ones added afterward.
- Write into the contract that a liftgate or residential fee not requested on the booking is payable only with proof, such as a photo or a consignee statement showing there's no dock.
- Run your customer address file through the carrier's classification tool every quarter, and challenge business addresses that were misclassified.
Paying re-delivery fees without evidence of a real attempt
Re-delivery and failed-delivery fees are easy to bill and hard to disprove, especially when the driver never actually reached the consignee. Some carriers charge the full minimum again, which can double the cost of a small LTL shipment.
What to do instead: make the fee depend on evidence. The contract should require a geotagged, timestamped attempt record, plus a photo where practical. The fee should apply only when the consignee caused the failure: closed during posted hours, refused delivery, or missed a confirmed appointment. Failures caused by the carrier, such as arriving outside the appointment window or bringing the wrong equipment, aren't billable.
Then decide who ultimately pays. If the consignee caused the failure, your terms of sale should let you pass the cost on. For international moves, check the Incoterms rule and the destination-charges clause before assuming the buyer pays. Under DAP, for example, the seller carries delivery risk, so a failed-delivery dispute can land on your bill.
Signing a fuel surcharge table you can't recalculate
Fuel surcharge mistakes are rarely dramatic. They're small and they recur on every invoice. The usual culprits: the index isn't named, the peg is set low, the lookup date is vague, and the percentage gets applied to accessorials as well as linehaul.
Say a contract pegs diesel at $0.80 per liter and adds 1% for every $0.02 above that. With the index at $1.00, the surcharge is 10%. On a $2,000 linehaul that's $200. If the carrier uses the previous week's higher index ($1.04, so 12%) and also applies the surcharge to $400 of detention and tail-lift charges, you pay $288 instead of $200. That's a 44% overcharge on fuel for one shipment. (Hypothetical figures, chosen to show the mechanics.)
What to do instead: name the index. Examples include the US EIA weekly diesel price, the EU Weekly Oil Bulletin, or a published national retail diesel price in markets such as India, where prices vary by state. Fix the lookup rule (the index in effect on the ship date) and state that fuel applies to linehaul only. In ocean contracts, ask how the bunker adjustment factor (BAF) is calculated and how often it changes. Then load the table into your TMS so every invoice is recalculated automatically.
Auditing the rate but waving accessorials through
Many freight invoice audit programs check the base rate against the contract and approve everything else. An accessorial charge audit needs its own rules, because these lines are where codes go undefined, evidence goes missing and duplicates turn up.
What to do instead: set up audit logic along these lines:
- Auto-approve an accessorial only if its code is in the contract exhibit and matches a pre-authorization or booking reference.
- Hold any accessorial without attached evidence (timestamps, photos, terminal records) and send it back to the carrier for support. Don't reject it outright.
- Flag duplicates, such as the same detention hours billed on both the pickup and delivery invoices, or the same container day billed by both the terminal and the carrier.
- Reject anything billed after the contract's billing deadline, commonly 30–60 days.
- Keep a dispute log with reason codes so carrier reviews rest on data.
Outsourced audit providers typically charge a low single-digit percentage of audited spend or a share of recoveries; terms vary by contract. Ask what proportion of their recoveries comes from accessorials versus rate errors. That tells you how deeply they check the accessorial lines.
Disputing charges one by one instead of fixing the causes
Winning disputes doesn't lower next quarter's bill. Carriers price expected dwell time and failed deliveries into future bids, and facilities known for long waits get worse rates or get refused.
What to do instead: report freight accessorial charges every month by facility, consignee, carrier and charge code. Measure them as a percentage of total freight spend against your own baseline. Most of the cost usually traces to a handful of docks and customers. Fixing those, through appointment discipline, extra dock hours or customer delivery requirements, does more than any dispute.
Make the contract run both ways, too. If you pay detention, the carrier should pay a late-arrival or failed-pickup charge. If you pay TONU, the carrier should pay when it accepts a tender and doesn't show.
Here's a decision rule for your next bid: before any lane goes out to tender, check that the carrier contract terms include a priced accessorial exhibit, a precedence clause, evidence requirements, a billing deadline and a fuel table you can recalculate. If any of those is missing, the linehaul rate you're comparing isn't the price you'll pay.
Quick answers
What's the difference between detention and demurrage?
In ocean freight, demurrage covers a container sitting at the terminal beyond free time. Detention covers the carrier's equipment kept outside the terminal too long. In trucking, detention means the time a driver waits at your dock beyond free time. That's why contracts should define each term rather than rely on industry usage.
How much free time should I ask for on truck detention?
Two hours at each pickup and delivery is a common starting point in North America and much of Europe. Live-unload operations with long cycles sometimes negotiate three. A clear rule on when the clock starts, plus a requirement for timestamped evidence, matters more than the number of hours.
Can I refuse to pay an accessorial that isn't in my contract?
If your contract says uncontracted charges need prior written approval and that your accessorial exhibit overrides the carrier's tariff, you usually have solid grounds to dispute them. Enforceability depends on the contract wording and local law, so have a qualified transport or commercial lawyer in your jurisdiction review the clause.
Should I outsource freight invoice audit or keep it in my TMS?
Many mid-size shippers do both. TMS rules handle rate and fuel checks and catch obvious accessorial errors before payment, and an outside provider audits the exceptions, ocean D&D and multi-country invoices. Outsourcing tends to pay off when you ship across many carriers, currencies and modes.
Do fuel surcharges apply to accessorial charges?
Only if your contract allows it, and most shippers should insist that it doesn't. Fuel surcharges are meant to cover fuel used on the move itself, and waiting time or a liftgate uses little or no extra fuel. State that the surcharge applies to linehaul only, and check every invoice against that rule.
Written by the Fleetmesh Tech editorial team. Prices, features and rules change often - confirm details with the vendor or a licensed professional before you decide.